It's time to jump in!

I've noticed that since I have rebuilt the site (and I know I still have a long way to go... sorry I havn't added the branding back) we're missing all the forum action.

Tim has broken the ice, looking for help on an Integrex 300 wiht Matric control. Have a look here.

 To cut a long story short, it goes a little like this:

"My problem is that on the Integrex when programming the sub spindle I dont know the correct way to get my spindle rotation right when using the T Drill for the tool sequence data.I know that it ask for Face or Back so I use back ,then set the position at 180 deg. But do I use the EDGE or EDGE BAK-(Pink Highlight). Also in the tool data page do I use Right hand rotation like normal when using the sub spindle.


Thanks Tim"

 So if you can help him then bounce over to the forums.